What is going on
Leaks come from failed fittings, pinholes in copper, cracked PEX connections, worn valve packing, loose drain joints and corroded galvanized pipe. Some are one-time events. Others are a symptom: pinholes that keep popping up in different spots usually mean the copper is thinning from the inside, and patching one at a time becomes expensive. We tell you which kind you have so you can decide between a repair and a bigger fix.
What we check
- 01
Leak source confirmed
Exact fitting or section identified before we cut.
- 02
Pipe material
Copper, PEX, CPVC or galvanized dictate the repair method.
- 03
Surrounding condition
Pipe near the leak checked for thinning or corrosion.
- 04
Water damage
Insulation, drywall and framing checked for wet materials that need drying.
- 05
Pressure test
System pressurized after repair to confirm no leaks remain.
Your options
Fitting or section repair
Single failed joint or short damaged section.
Line reroute
Problem section bypassed with new pipe run through the attic or wall.
Repipe recommendation
Repeat pinholes or widespread corrosion where patching is no longer sensible.
Before we get there
If water is actively coming out, close the main shutoff. Move belongings away from the wet area and set towels or a bucket down. Turn off breakers to circuits near the leak if water is close to outlets or fixtures.